High Tech 19th Century Public Safety Communication

by Doug Meil, August 30, 2026

I was in San Francisco recently walking around Union Square and a few objects caught my eye.  They were public safety call boxes, one for Police and one for Fire.  Both were marked “Department of Electricity,” which sounded old but still awesome.

San Francisco – Union Square (Photos by Doug Meil)

The Police call box looked like a relic and I thought was perhaps left in place for quaint historical vibes.  The Fire call box, on the other hand, had clearly been retrofitted for modern use.  This left me wondering when boxes like these were installed, how they worked, and where the signals were going.  I contacted San Francisco’s Water, Power, and Sewer Department—which I thought was a likely descendant of the Department of Electricity—with some questions, and they replied quickly with answers and some helpful links.

Planning for the call box system started in 1863, and it went operational in 1865. In 1900, San Francisco’s Fire Alarm and Police Telegraph Department was superseded by said Department of Electricity, which gave me a clue as to the approximate (or at least maximum) age of the Union Square call boxes.  I was also surprised to learn that according to a 2012 SFGate article that a great many Police and Fire boxes such as these were still active in San Francisco at the time.  A 2024 San Francisco Standard article, however, reported that fewer and fewer of these remained operational, which while disappointing wasn’t entirely surprising.  But the fact that any 19th century technology was still peeking into the 21st century was fascinating.  I had to find out more. 

Digging Deeper – Police

Fortunately, my hometown of Cleveland, Ohio, has some great resources for further inquiry.  My first stop was the Cleveland Police Museum, where I was able to find a very similar type of Police call box.

Cleveland Police Museum – Murphy Call Box (Photos by Doug Meil)

The Murphy call box was first introduced to Cleveland in 1887, and by 1928 there were 640 such devices.  The call box pictured above dates to about 1900.  According to the museum these call boxes could still be seen on Cleveland streets as late as the 1970’s, although their importance started to decrease with the deployment of Police radio communications in 1929.  Originally the call box was just a telegraph, and a patrol officer would do 1 crank for their required periodic check-in to signal everything was ok, or 2 cranks to call for assistance.  The phone receiver as seen in the right photo was a later upgrade.  Police call boxes went to a Police dispatch center which operated independently from the Fire dispatch center.

How was this call box opened?  With a key, of course!  Each key was attached to a Police whistle.

cleveland police museum

Cleveland Police Museum (Photo by Doug Meil)

Digging Deeper – Fire

My next visit was to the Western Reserve Fire Museum in downtown Cleveland, Ohio which exists not only in a former Fire station but also the former Fire central dispatch as well.  The museum has a Gamewell Fire call box which looks a lot like the one from San Francisco.

Western Reserve Fire Museum – Gamewell Fire Call Box (Photos by Doug Meil)

Fire call boxes were first introduced in Cleveland in 1864 and used until 1999, and there were over 1,300 boxes installed at one point.  Each call box was numbered (note “2153” in the left picture) and was activated by first opening the outer door and pulling the lever to activate the alarm. 

Western Reserve Fire Museum – Gamewell Fire Call Box Interior (Photos by Doug Meil)

Opening the second “PULL LEVER” door exposes the internal gearing (left picture).  Look closely at the silver center wheel in the right picture and note the pattern of the teeth:  2, 1, 5, 3.  When an alarm is pulled it will ring out 2 bells, pause, ring 1 bell, pause, ring 5 bells, pause, then ring 3 bells.  This is how the device identifies itself as call box 2153.

There is also a telegraph key in the lower center interior for tapping out messages.  But what to transmit?  The origins of Morse Code date to the 1830’s and had been utilized for years before the advent of the first call box, so that certainly could have been an option.  But there were a few problems with utilizing a generalized communication protocol during this era.  Although Morse code could provide flexibility in expanding the range of possible things to say, it would also take a lot of tapping – which would not only take more time but also present more opportunities for miscommunication and error.  As these call boxes were intended for use during emergency situations, time was of the essence. 

To address this issue Cleveland Fire had a specialized code system.  This system could say fewer things, but those things could be expressed very quickly, and bidirectionally.  “1-2 I understand” in the chart below would, for example, require tapping out one bell, pause, then two bells.

cleveland fire department telegraph signal code

Western Reserve Fire Museum – Fire Signal Code (Photo by Doug Meil)

cleveland fire department fire dispatch center

Western Reserve Fire Museum – Fire Central Dispatch (Photo by Doug Meil)

As I understood the process from the Western Reserve Fire Museum docent, Fire call box signals were transmitted to Fire Central dispatch, which as previously stated was separate from Police Central dispatch.  Each column in the photo above represents a group of call boxes, and thus every call box would be wired to ring out in a specific column, and it was also possible for dispatch to respond as well.  This was a physically enormous system-the signal handling portion of Fire central dispatch was U-shaped and the section pictured above only represented about a quarter of total footprint.

The power system that enabled all of this to work went fully across the back half of the room.  Dispatch must have been incredibly noisy too as the clank-clank-clank of bells were accompanied by the chunka-chunka-chunka of tape systems that printed out the signals to ensure that no messages missed, with dispatch staff reading messages and forwarding to the appropriate stations, all under emergency conditions.  I would have loved to have seen this in action.

cleveland fire department

Western Reserve Fire Museum – Signal Tape System (Photo by Doug Meil)

But who does what in response to a given fire alarm?  All of that had to be thought and communicated ahead of time.  Given that there were over 1,300 Fire call boxes, those plans were written and typed onto over 1,300 index cards – one card per call box – detailing which Engine and Hook & Ladder companies were responsible for initial and backup responses.  There must have been copies of all these cards distributed across each Fire station and just ensuring that the cards were up to date would have been a lot of work.

Western Reserve Fire Museum (Photos by Doug Meil)

Lastly, no job is finished until the paperwork is done.  Station activity would be hand-recorded in a logbook.  The color choices were deliberate – Fire call box responses are recorded in red, other activity in blue.  All handwritten.  Calls for Service reporting is computerized now, but back in the day it was effectively reading through logbooks like these and hand-compiling results.

fire station log

Western Reserve Fire Museum – Station Activity Log from 1964 (Photo by Doug Meil)

It is truly astounding to me how many technological and process issues had to be figured out for this to work:  infrastructure investments (telegraph lines, call box installation, power sources, maintenance & upgrades), design and deployment of a multitude of operational processes, training, and more.  And this was before radio, the telephone, and cellular communication, let alone computers!  Call boxes might be history, but they should not be forgotten.

Special Thanks

Thanks to the City and County of San Francisco’s Water, Power, and Sewer Department, and to the Cleveland Police Museum and the Western Reserve Fire Museum in Cleveland, Ohio.

Links

  1. San Francisco
    1. Call Box History
      1. https://sfmuseum.org/hist10/cfaspaper.html
      1. https://www.policeguide.com/San-Francisco-Dept_-of-Electri/san-francisco-dept_-of-electricity.html
    1. Articles
      1. https://www.sfgate.com/bayarea/article/why-s-f-still-counts-on-street-fire-alarm-boxes-3081293.php
      1. https://www.sfgate.com/local/article/San-Francisco-historic-fire-alarm-boxes-SFFD-16307778.php
      1. https://sfstandard.com/2024/05/11/san-francisco-emergency-call-boxes/